Ring Size Guide
Method 1: Measuring Your Finger
Cut a strip of paper or a piece of string approximately 10 centimeters (cm) in length.
Gently wrap the paper or string around your finger at the point where you intend to wear your ring. Make sure it's snug, but not overly tight.
Mark the spot where the end of the string or paper overlaps with a pen.
Unwrap the string or paper and align it against a ruler or tape measure. Measure the length (in millimeters) from the end of the string or paper to the marked spot.
This measurement is the circumference of your finger. Refer to our size chart to determine your corresponding ring size.
Method 2: Measuring an Existing Ring
Locate a ring that fits comfortably on the finger where you plan to wear your new ring.
Measure the inner diameter of the ring using a ruler or tape measure. Ensure your ruler has millimeter (mm) markings.
Lay your ring flat on the ruler, and measure across the inside of the ring from edge to edge – this is the part that touches your finger.
Refer to our size chart to convert your measured diameter into the appropriate ring size.
- Choosing a selection results in a full page refresh.
